Installation position of air heating bath pole Correct use of air heating bath pole

1, a dry and clean bathroom environment can prolong the service life of Yuba.

2. When using yuba, be careful not to splash water on it. Yuba's waterproof light bulb has waterproof performance, but the metal fittings in the body can't do this, that is, the metal in the body is still conductive. If water is splashed, it will lead to danger such as short circuit of power supply.

3. The temperature of the wind-temperature yuba is slow, so you can turn on the wind-temperature yuba ten minutes before taking a bath, which is more comfortable when taking a bath.

4. Don't switch Yuba frequently. Frequent switching of Yuba will not only consume a lot of electricity, but also affect the service life of heating bulbs.

Installation position of air-heated Yuba:

1. Because the air-cooled yuba is different from the lamp-heated yuba, the principle of the air-cooled yuba is to use ceramic PTC to heat, and then spread the heat to the whole space through the wind wheel, so the whole space becomes warmer, so it is not necessary to install the air-cooled yuba in the center of the bathroom now, just choose a place above the bathroom near the shower area (it is best to avoid splashing water).

2. If there is dry-wet separation in the bathroom at home and a shower partition is installed, you can choose to leave half of the installation position of the air-cooled Yuba in the partition, or you can choose to install it at the top outside the partition. The reason is very simple, just like the first one, because air heating is heated by blowing air through the heater, it can play the role of constant temperature and heat preservation no matter where it is installed indoors. To put it bluntly, it is the same as air conditioning.

3. Although the air-cooled Yuba blows warm air, if there is wind blowing in the shower and there is water on your body, any wind will feel cold in winter. It is best not to install all the air-cooled yuba above the shower area, or the tuyere should not face the shower area.

4. Of course, the quality of air-heated Yuba also depends on it. It is only a matter of time before the low-power air can warm the whole bathroom in the distance. Therefore, the air energy yuba with power below 2000W, including ordinary lamp heat yuba or lamp heat+air energy yuba, is installed in the shower partition or shower curtain.

If the actual power of the Yuba is 2400W and the area of the bathroom is less than 5 square meters, then the air-cooled Yuba can be installed anywhere you like, without being installed in the shower partition or shower curtain, because the 2400 W air-cooled Yuba can make every corner of the bathroom full of warmth.

Extended data:

Cleaning method of air-heated yuba;

1, long-term use of Yuba, the switch panel is stained. When cleaning these stains, first cut off the power supply (neutral line and phase line). After confirming that there is no electricity, remove the bulbs in Yuba one by one and wipe them with a rag stained with a small amount of neutral detergent. After wiping off the stain, dry it with a clean dry cloth.

2. Remove the tension spring, that is, there are four springs at the four corners of the Yuba box, so remove it. And use neutral disinfectant or cleaner to wipe the surface of Yuba and the surface of light bulb. After all these are wiped, clean the inside of the cabinet. Although the cabinet is fixed on the roof, in order to ensure the service life of Yuba, it still needs to be thoroughly cleaned.

Baidu encyclopedia-wind-warm bath bully