What does the driving computer display screen of Beiqi New Energy 214EV series look like, and what is the meaning of the information on it?

1) The display screen of the driving computer can display a variety of different driving interfaces, and the switch can be adjusted by pressing button A\B:

Digital current value: indicates the current value of charging and discharging the power battery, with a positive value indicating that the power battery is discharging and a negative value indicating that the power battery is self-charging;

digital drive motor speed value: indicates the current drive motor speed;

instantaneous power consumption: indicates the instantaneous power consumption intensity when the vehicle is running, and the power consumption increases from the middle to both sides in turn;

maintenance mileage: the initial default maintenance mileage of the instrument is 5km, and then every 1km. When the mileage from vehicle maintenance is less than 15km, every time the vehicle hits the On gear, the driving computer display screen will display a text prompt "Please maintain the vehicle" for 5s, and then it will be automatically eliminated. Tip: When the instrument prompts "Please maintain the vehicle", please go to the 4S shop for vehicle maintenance as soon as possible. When the instrument is in the maintenance mileage interface, you can reset the maintenance mileage to 1km by pressing the button A for 1 seconds.

average power consumption

average power consumption indicates the average power consumption when the vehicle is running, with kWh/1km as the unit, that is, degrees /1km.

tip: the displayed power consumption may be relatively high in the first period of time when the vehicle is started, and the average power consumption tends to be stable with the longer driving time. The average power consumption can help the driver to develop good driving habits.

2) Electricity meter

The electricity meter * * * is divided into ten cells, and each cell represents 1% electricity.

when there are 3 cells left, it will be displayed in orange;

when there is only one cell left, the displayed segment is red, so please select the nearest charging pile to charge the vehicle as soon as possible.

3) Button A/B

There are two buttons at the lower end of the instrument, which are called Button A and Button B from left to right respectively, and their functions are as follows:

Button A:

Button B:

4) cruising range

indicates the distance that the vehicle can travel with the current electric power, and the minimum display accuracy of the instrument is 1km. When the cruising range is displayed as "-"and the energy bar disappears, it may be caused by the following reasons:

The remaining power of the power battery is too low, so you should drive slowly and charge the vehicle as soon as possible

When the vehicle just shifts to the On gear, the vehicle controller starts to calculate the cruising range. The instrument will display the current cruising range after a delay of several seconds

Note: the cruising range will be affected by data such as driving mode, weather, temperature, driving environment, etc.

5) Gear display

The gear display of the vehicle is located on the LCD screen of the driving computer, and there are four gears, namely R, N, D and E, in which E indicates that the vehicle is in the braking energy recovery state, and at this time, the upper diagram will appear on the left side of the gear, with the numbers 1, 2 and E.

6) Total mileage and subtotal mileage

The total mileage is the accumulation of all the mileage of the vehicle since it leaves the factory. The reset setting cannot be made by the button. The digital significance of the total mileage is 6 digits, and the accuracy is 1km. The display range is -999999km, and it will stay at 999999 km when it reaches the maximum value.

the effective digit of subtotal mileage is 4 digits, and the accuracy is .1km .. The display range is -999.9 km. When the maximum value is reached, it will be cleared automatically and the subtotal mileage will be calculated again. When the vehicle stops, the calculation of subtotal mileage stops. Pressing button B for more than 3 seconds will clear the subtotal mileage.