How to use electric starter generator?

Correctly start the electric starter generator operation steps:

Article 1 Before starting, turn the generator switch to the "ON" position and put the speed control handle to the lowest position. Turn the choke switch to the "OFF" position, except in areas where the engine is hot or the ambient temperature is high.

Article 2. Turn off the output circuit breaker.

Start the generator set with the third hand, gently pull the start handle until you feel resistance, and then pull it out quickly. Don't pull out all the wires. If the car breaks down repeatedly, put on the choke and try again.

Article 4. Pull the engine at idle speed for 4 ~ 5 times (more times are needed when the weather is cold in winter), so that the internal parts of the engine can be lubricated and the residual exhaust gas in the cylinder can be discharged.

Article 5. Open the throttle switch and start the generator set.

Article 6 After the generator set is started at room temperature, it needs to run for 1 ~ 2 minutes for preheating; When the weather is cold, it is necessary to extend the preheating for 3 ~ 5 minutes. During the warm-up, check whether the idling state of the generator set is normal.

Article 7. Check whether the output voltage, frequency and other instrument displays are normal. If it is not normal, it needs to be adjusted to the normal value.

Article 8 after the preheating of the generator set is completed and everything is normal, close the output circuit breaker to supply power to the load.

Article 9. Check whether the output voltage, frequency and other instrument displays are normal.

Article 10 The unit shall not be started continuously for more than three times, and the interval shall not be less than 2 minutes. If it can't be started for the third time, it should be carefully analyzed and checked. After the fault is confirmed, it is allowed to start for the fourth time.

Article 1 1 When the unit fails to start for the first time, the reason should be carefully found out. If the reason is unknown, it should not be started again.