What should I pay attention to when laying the floor in this weather?

I don't know if you are from the south or the north. Generally, you should pay attention to winter paving: in winter, you should leave a larger floor seam to avoid the floor bulging after the temperature rises in summer.

Common quality problems of solid wood floor pavement

The common quality problems in the installation of solid wood flooring include empty drum noise, uneven surface, lax flat-fell seam and local arching.

1, empty drum noise is caused by weak fixation, mainly because the number of nails between wool board and keel, wool board and floor is small or weak, sometimes; Shrinkage caused by moisture content change or unqualified glue solution. Therefore, it is particularly important to strictly test the quality of plates such as water content and adhesive. It can only be used after inspection, and there should not be too few nails during installation.

2. The main reason of uneven surface is uneven base or floor strip deformation and arching. During construction, the keel surface should be leveled with a spirit level. If it is uneven, it should be adjusted by stowing wood. Small ventilation slots should be made on the keel. There should be a ventilation gap of 10 mm between the board edge and the wall surface. The material of thermal insulation and sound insulation layer must be dry to prevent the solid wood board from bulging after being damp. The surface flatness error of solid wood floor should be within 65438 0 mm.

3. The reasons for lax flat-fell seam are not only nonstandard installation during construction, but also large error in plate width and size and poor processing quality.

4. The main causes of local bulging are not only the deformation of the plate due to moisture, but also the fact that the flat-fell seam of the plate is too small or seamless, and the ground is wet due to water leakage such as water pipes during use. After the floor is paved, the paint film should be complete. In daily use, water should be prevented from flowing into the lower part of the floor, and the accumulated water on the surface should be cleaned in time.

Construction acceptance of solid wood floor

The material variety and grade of the solid wood floor should meet the design requirements, the moisture content should be around 10% (there are some differences in different regions), the wooden keel and stow-wood have been treated with anti-corrosion, the wooden keel installation should be firm and straight, the spacing and fixing method should meet the specification requirements, the board surface should be nailed firmly, without looseness, firm paste and empty drum, and the variety of glue used should meet the specification requirements.

Visually check whether the wooden floor surface is planed and polished, with no scars, clear patterns, consistent color of oily surface, correct paving direction, tight joints, staggered joints and clean surface. The skirting board shall be laid with tight joints, smooth surface and consistent height and wall thickness. Check with 2m ruler, the ground flatness error is less than 1 mm, the gap width is less than 0.3 mm, the straightness error of skirting board is less than 3 mm, and the straightness error of flat-fell seam is less than 2 mm. ..