Traditional Culture Encyclopedia - Weather inquiry - Reveal the secret! The reinforced concrete decorative strip is aging, see how I renovate it!

Reveal the secret! The reinforced concrete decorative strip is aging, see how I renovate it!

Aging of reinforced concrete decorative strips is a common problem, but do you know how to renovate them? This article will introduce the steps and precautions of renovation in detail, so that you can easily repair the aging decorative strips.

Basic tools

To decorate the decorative strip, tools such as saw blade, hand saw, tape measure, square ruler, trowel, wallpaper knife, 2m ruler, grey knife, wire brush, Mo Dou, hammer and steel nail need to be prepared.

construction sequence

The steps of decorating decorative strips include wall inspection, tool preparation, assembly and bonding. In the process of construction, we should pay attention to the weather and the cleanliness of the wall.

Wall inspection

Before decorating the decorative strip, it is necessary to check the flatness of the wall. Use 2m guiding rule to detect flatness, and the deviation is less than 5mm. Dust and stains on the walls also need cleaning.

Tool preparation

All the tools need to be ready before the decoration. In addition, the weather also needs to be suitable, the temperature is between 5℃ and 38℃, and the wind force does not exceed 5.

Start assembly

When assembling the decorative strip, try to leave the assembly seam in the middle of the whole EPS component, which looks more harmonious. In addition, the dust and stains on the wall also need to be cleaned.

act in close coordination (with)

When pasting decorative strips, it is necessary to mix the mortar according to the recommended amount of water, and then start pasting. Note that too cold or too hot will affect the viscosity of mortar, so you need to choose a good weather.

Share the results

Renovating decorative strips is an interesting job. Don't forget to share your achievements when you are finished!