Traditional Culture Encyclopedia - Weather inquiry - Can you blow white when crouching? Why can't it blow white when squatting?

Can you blow white when crouching? Why can't it blow white when squatting?

Many people like to decorate in summer and think it is well ventilated at this time. The sun is big, it dries fast, and the smell of formaldehyde is more volatile. So, can you blow white at volts? Why can't it blow white when squatting?

Can you blow white when you lie down?

It is recommended not to scratch white light after falling in. Because the air is too humid, the wall foundation is not easy to completely dry. If it is not thoroughly painted, it will easily crack the paint surface in future use, so the process of scraping white (brushing putty) should avoid wet weather, such as rainy days and rainy days.

What do you mean by scraping white?

Scraping white is a kind of indoor wall decoration in buildings, and it is also the most common wall decoration in ordinary houses. In fact, white scraping is to mix building white powder, talcum powder and cellulose (a chemical binder, which is easily soluble in water) on the rough surface of cement to fill the sand holes in walls and ceilings and paint them. The thickness is about 1mm, and it is still good after drying, and it is not easy to fade. I'm just afraid of water. If soaked in water, it will fall off after a slight scratch. Its construction is more common in ordinary houses at present, and it replaces the original large-scale white powder fiber slurry wall, which has the advantages of low cost, fast construction speed and easy maintenance.

work progress

One (remove the original white). It's good to be as clean as white, even if you spray water, it won't move.

Second (interface processing). Paint the wall and fix the wall chain.

Three (local plaster plaster bandage). Check whether there are cracks on the wall surface, such as feed holes on the wall surface and gypsum board molding gypsum line. If there is a gap, first fill it with plaster, then brush it with white latex and put a bandage on it. Check whether there is rust on the wall. If there is, knock it off with a machine and fill it with plaster.

Four (batch plaster scraping). Attention; The ceiling of all houses should be plastered with plaster, because the ceiling is too uneven, and it should be scraped white directly after shoveling. Gypsum is very different from white. Before scraping, the work of gypsum is: all the places where bandages are attached, gypsum board and cement surface. You must scrape off the plaster.

Five (batch scraping). Scraping is very important, at least twice. Scrape everything clean for the first time, and don't miss anything. After the first job, check the roof and walls for rust spots. Shave it a second time. After working in Dabai, it is necessary to ventilate, not as stuffy as the wind, and the windows can be opened and closed for a while, which is treated differently in different weather.

Six (completely dry after white sandpaper polishing). Polishing is a necessary work before brushing [spraying] latex paint. But at the same time, sanding sandpaper is a very important part of scraping white. Scrapers, seals, purlins, pouches, etc. that fall off when construction workers scrape white should be ground off.

Seven (protection). So as not to rub the latex paint.

Eight brush (spray) latex paint. (Note: The above is the main procedure of scraping white. "Good white" also needs other targeted "procedures". )