Traditional Culture Encyclopedia - Hotel accommodation - What should I do if the shower head doesn't stick and always falls down? Is the base of the general shower nozzle universal?

What should I do if the shower head doesn't stick and always falls down? Is the base of the general shower nozzle universal?

Shower is a must in the bathroom. It looks unremarkable at ordinary times, but it has a great effect. It is necessary to take a bath. After a long time of use, you will find that the shower head will always fall off, which is a headache. I don't know what to do. Here, Bian Xiao will tell you in detail what to do if the shower head doesn't fall off. Is the shower head base universal? How to install the fixed base of shower head?

The shower nozzle is not sticky and keeps falling off. What should I do?

1, you can take off the nozzle, wrap it in plastic wrap a few times, or put it on again, so that the nozzle will tighten and not fall off.

You can wrap the raw material tape around the nozzle, and then tie it tightly, so it won't fall off again.

3. It may be that there is something wrong with the soft rubber of the buckle, which makes the shower nozzle unable to be fixed. At this time, a new software needs to be replaced.

4. If the screw of the shower seat card becomes loose, the user needs to tighten it with a screwdriver.

5. If the above methods can't solve the problem that the nozzle can't be stuck, it means that the nozzle is broken and needs to be replaced with a new one.

Is the base of the general shower universal?

Shower bases are universal, and there are several kinds of shower bases. Here are some common ones:

1. Convenient: This is a tradition. Can be pulled freely, mainly used for fixing.

2. Overhead type: This shower room is relatively large. It is installed on the wall, which is flexible to use and can adjust its functions according to its own needs.

3. Formula: This spray is powerful enough to stimulate the body's acupoints.

4. Turbine type: This water flow will be concentrated into a water column, which will make people's skin feel slightly itchy.

Installation method of shower head fixing seat

1. Prepare the screwdriver, raw material belt and shower head first, and turn off the water valve before installation.

2. The two joints are coated with thread sealant or wrapped with raw material tape, and then screwed into the hot and cold water supply pipe.

3. Adjust the two connectors so that the center distance is150mm.

4, and then screw the decorative cover into the joint, pay attention to the wall.

5. Install the sealing gasket into the nut, rotate it to the connection position and tighten it.

6. First remove the fixture from the bracket, take out the plastic sleeve, and take out the uterine screw in the inner cavity of the bracket.

7. After adjusting the height of the shower hose, choose a suitable height position for installation, then install the bracket bottom plate on the wall and make several holes.

8. Then tighten the screws with a screwdriver, so that the shower base is installed. When installing, be careful not to break the water pipe on the wall when punching holes in the wall.