Traditional Culture Encyclopedia - Hotel franchise - What is the design method of hotel bed decoration?

What is the design method of hotel bed decoration?

(1) Open the bedstead pad.

Bend down, lift the bedstead slightly with both hands and slowly pull it out, about 50 cm away from the headboard.

(2) billing

Grab one end of the sheet with your left hand, hold the head of the sheet with your right hand, throw it to the bed, and then open the sheet conveniently.

(3) Dumping orders

Hands apart about 80- 100 cm, palms down, grab the head of the bed sheet, lift it about 70 cm high, lean forward slightly, throw it out hard, and hang the bed sheet evenly around the bed. The paper should be face up and centered.

(4) wrap angle

When wrapping the bed, tuck the drooping sheets under the mattress; Wrap corners: that right hand pull up the drooping sheets on the right side, the left hand folds the sheets on the right corner into a right angle, then the right corner pulls down the folding angle vertically to wrap the sheets into a right angle, and the right hand tucks the remaining drooping sheets under the mattress. Every corner is important, and it is a right angle.

(5) Bedding quilt cover

Put the quilt into the quilt cover, with the four corners symmetrically laid flat. The distance between the quilt and the bed head is about 30cm, the quilt head is folded back by 30cm, and the distance between the quilt head and the bed head is about 60cm, and the two sides naturally droop.

(6) Pillow case

Pillow core sleeve must be full and smooth, and the pillow core is not exposed.

(7) put a pillow

Put two pillows in the middle, about 5 cm away from the bedside, with pillow pockets facing the bedside table.

(8) Bed tail cloth

Lay the cloth at the end of the bed flat, and don't deviate from the center line. Both sides droop naturally, the distance is equal, and the tail droops naturally, about 1 cm from the ground.

(9) Reset the bed.

Bend down and slowly push the prepared bed to the headboard, aiming at the headboard.