Steps of making the bed

The operation flow of bed making is as follows:

1. In the process of making the bed, the operation should be fast, skilled and accurate.

2. The wrap angle of sheets should be 45 degrees inside and 90 degrees outside.

3. When laying plates, meet the requirement that the drum seam faces upwards first, and then meet the requirement of facing upwards.

4. When making the bed, it is found that there are stains on the mattress, which should be replaced in time; If you find that the sheets are damaged, stained or hairy, please replace them in time.

5. Bedding standard: 1) First open the quilt cover and check the quality; 2) The head end of the quilt is flush with the bedside; 3) The center line coincides with the center line of the bed; 4) The quilt is evenly covered in the quilt cover; 5) The four corners are positioned accurately and the quilt cover is flat; 6) The left and right sides and the end of the bed droop naturally, and the shop is paved smoothly.

6. In the process of making the bed, the standard for placing pillows is 1) Shake the pillow core loosely and lay it flat on the bed, paying attention to the trademark facing inward. 2) Hold the front ends of the pillow core and stuff it into the pillowcase. 3) Hold the bag mouth with both hands, and shake it while lifting it, so that all the pillow cores will enter the pillowcase. 4) Insert the pillow core into both sides of the pillow bag, tidy the bag mouth and pat it loose. Pillows must have full corners, flat and crisp appearance, and the pillow core is not exposed.

7. Pillow placement standard: 1) The two pillows in the big bed room are placed flat on the bedside with opposite openings; 2) The pillow in the standard room is placed flat in the center of the bedside, and the opening deviates from the bedside table.