Is it the low water pressure or the shower?

1. Is the tap water pressure at home lower than before? If yes, you need to find a water company to check the water supply pipeline and pressure.

2. The pipeline valve connected with the water heater is slightly opened: the water inlet valve is opened.

3. Because the living floor is on the high side and the water pressure of the water source is low, the water output is smaller after decompression by the mixing valve. At this time, it is suggested to connect a booster pump in series between the water supply valve and the water inlet of the water heater.

4. The water mixing valve is inherently insufficient, and its diameter is small, which reduces the water output due to throttling: the water inlet end of the water mixing valve can be disassembled and connected to the water supply valve of the water heater with a hose, or the hose of the shower can be directly connected to the hot water outlet end of the water heater, and the quality of the water mixing valve can be distinguished according to the water output of the shower; On the premise that the water pressure of the water source meets the requirements, replace the mixing valve of Zheng Zhuang brand.

5. Improper installation, rubber ring deformation, uneven or thin outlet pipe joint, mismatch between hose and shower head, etc. Select the appropriate hose and shower head according to the specifications, replace the rubber ring and reinstall it.

6. The nozzle is inherently insufficient, and the internal resistance is large, resulting in small water output: replace the nozzle.

7. The shower hose is broken, the hose is blocked, and the water can't come out: Chinese medicine protects the hose during use, and the crease not only affects the appearance, but also easily leaks because of repeated creases.

8. The nozzle is blocked, resulting in poor drainage. Generally, if the water in the home is too alkaline and contains some impurities, it is easy to block the small holes of the shower; In addition, air sediment dust will also enter the interior through the small holes of the shower head, which will also block the shower head for a long time; Improper adjustment of the nozzle may also lead to the increase of foreign body scale.

Extended data

Shower maintenance skills

Please ask experienced professionals to carry out construction and installation. When installing, the shower should try not to bump against hard objects, and do not leave cement and glue on the surface to avoid damaging the luster of the surface coating. Special attention should be paid to removing the sundries in the pipeline before installation, otherwise the shower will be blocked by sundries in the pipeline, which will affect the use.

When the water pressure is not lower than 0.02mPa (i.e. 0.2kgf/ cm3), after a period of use, if it is found that the water output is reduced, or even the water heater is turned off, the net cover can be gently unscrewed at the water outlet of the shower to remove impurities, which can generally be restored as before. But remember not to dismantle the shower head forcibly, because the internal structure of the shower head is complex and unprofessional.

Turn on and off the faucet of the shower. When adjusting the water outlet mode of the shower, don't use too much force, just turn it gently. Even traditional faucets don't need much effort. Pay special attention not to support or use faucet handles and shower racks as handrails.

The metal hose of the bathtub shower should be kept in a natural stretching state, and should not be coiled on the faucet when not in use. At the same time, be careful not to form a dead angle at the joint between the hose and the faucet, so as not to break or damage the hose.

Baidu encyclopedia-shower