Where can I use the camera?

Photography has no restrictions on the placement of cameras, right?

I'm telling you, because if the camera is placed in the south, it's easy to glare. It is best not to put it in the south, because the wind in the south or southeast is usually humid. When the camera is used to take pictures of the sun, there will be light spots or faculae in the photos or videos, and these light spots or faculae also have a certain corresponding relationship with the position of the sun in the lens.

When taking a full-length photo, the camera should be positioned at the waist of the subject, so that the leg lines of the subject can be appropriately lengthened, so that the leg lines of the subject appear slender, the head of the person can appear small, and the upper body can be shortened to a certain extent, resulting in long legs, small head and high figure.

According to my experience, it is usually recommended to lay flat, that is, the base touches the surface and the lens is horizontal. When you go out, the camera is at the top and at the bottom. There is a simple reason. If the lens is facing up, dust will deposit on the CCD. On the contrary, it will only be relatively easy to clean at the end of the lens. It is usually deposited directly on the bottom of the cassette without any influence. As for the contact area, don't think too much. As long as it is determined to be a soft material, it is enough to prevent hard impact. The lens and bayonet are very strong, so don't be too careful.

It depends on what kind of photos you want to take. Different styles and types of photos have different poses. Of course, there is no real fixed layout. This book depends on many factors, such as the location of your computer, whether it is lit or backlit, the height of the camera, the location of the subject and so on. The easiest way is to take a picture and tune it to the computer until you find your satisfactory position. And cameras are generally not as good as cameras. As long as it is not blurred, the image is clear.

The above are personal opinions and are for reference only.

I plan to shoot a video at dawn, record a conference video and have a 5D camera. It is reasonable to be entangled in not knowing how to place the seats. Please consult me.

Only one SLR camera can shoot the whole meeting with the following hardware conditions: 1, and the power adapter can ensure that the whole shooting will not be cut off. At the same time, reserve a battery in case of emergency during the meeting. 2. Prepare two large memory cards, which can ensure that the camera will not be unable to record the whole process due to insufficient capacity. 3. Prepare a notebook and a large-capacity mobile hard disk. When the meeting time is long, take advantage of the opportunity that there is no important speech during the meeting, quickly switch out the memory card that is almost full, transfer the contents on the card to the notebook, and back it up in the mobile hard disk. The purpose of this is to always keep a memory card that can be used for backup. 4. The camera should be equipped with a large zoom lens, and the focal length is preferably 24- 105 or 24-85. This kind of lens is more practical. 5. According to the size of the venue, choose a tripod, preferably a tripod with pulleys. This can stabilize the picture as much as possible in the process of moving shooting. When the above five important conditions are met, the camera position must be set at an angle that can take a panoramic view of the whole venue. If there is only one camera, and the whole shooting process can't be interrupted, then your seat can't be moved basically, and you can only reset your seat during the break of the meeting. Choose close-up and close-up seats as needed. At the same time, the lens can be switched as needed, and a memory card with larger capacity can be replaced. If the conference room is a long table and the podium is at one end of the long table, then the seats are located at the other end in the opposite direction, so that all the participants can be photographed all the time without changing seats. But this will lose the close-up or close-up of the podium speaker. If the podium is in the middle of a long table, the camera can only be located at one end of the table, because only in this way can all participants be photographed in the same position. The above are personal opinions and are for reference only.

How to understand the high and low position in photography?

The angle of photography is divided into flat shot, overhead shot and overhead shot, and the plane position is the position where the camera is placed during photography. High position, as the name implies, is a relatively high position. The position of the machine is higher than the position of the subject, which is often used for overhead shooting. For example, taking a red flower can overlook the upper part of the flower from a high position, and aerial photography can also be used to introduce the environment and show some magnificent troops. It is important to use high positions. Overhead shooting is used to shoot characters, which can show their depression.

Low-altitude cameras are mostly used for high-altitude photography, and the camera position is lower than the subject. When used to photograph buildings, aerial photography of low-altitude cameras can show the height of buildings. In TV movies in the 1970s, high-altitude cameras were often used to show the height of heroes and to compare their images. Low-altitude photography can be used to shoot portraits, and slightly inclined angle photography can make people look longer, which is the angle commonly used by photographers to shoot characters.