Modification method of synchronous control box of drx line machine

1, the first step of flat bed transformation-to the bed plate.

2. The second step is the reform of flat bed-installing new baki.

3. The third step is the transformation of flat bed-installing grid.

4. The fourth step is the flat bed transformation-after the bed board is installed.

5. The fifth step is the transformation of the column-removing the grid.

6. The sixth step is column transformation-removing the original bucky.

7. Step 7: Column transformation-install new bucky. Define the cross of the beam collimator as the coordinate axis, and determine the coordinate sizes of the above four mounting holes-put the detector into the new Bucky, and define the center of the detector as the coordinate axis-punch four through holes on the new Bucky backplane according to the coordinate sizes of the mounting holes, and then install.

8. Step 8: Column transformation-install the grid.

9. Step 9: Post-transformation-after installing the upper cover.

10, step 10: column conversion-detector placement.