How to adjust the horizontal line of the camera

How to level the camera when it is broken?

How to level the level: _

(1) Flat terrain: First, loosen the tripod fixing screws, and stretch the tripod close to yourself. The length of the tripod should not exceed the tip of your nose, and then fix the screws. Place the three tripods of the tripod between two observation points, open the instrument box after the tripod is roughly in line with the ground, and install the sighting part of the level on the tripod with connecting screws. _ The second step is to look at the position of the bubble in the circular level (pay attention to rotate the triangular spiral of the sighting part of the level roughly to the middle before installation). The direction of the round medicine bottle indicates that the direction is high. At this time, just hold one of the tripods (the other two are stationary) and move back and forth until the round bottle is basically in the center of the round bottle or in the circle of the round bottle. Finally, it is accurate leveling.

(2) Uneven terrain (steep slope): First, adjust the length of the three legs according to the terrain. If the slope is steep, you can let two long legs down and one short leg up. Similarly, make the level level roughly horizontal by visual inspection (then step on any two feet, leaving one movable for easy adjustment), or lift the tripod to make the air bubble roughly centered, and then level it with foot screws. _ Note: If the ground is soft, all three legs should be stamped firmly, and then rough and fine leveling should be carried out.

The automatic horizontal adjustment of Panasonic P2HD camera can be set through touch screen operation. First, switch the touch screen to the Austrian lens interface, then click the zoom icon on the upper right to open the photography interface with accurate depth of field, and select automatic horizontal adjustment. After the setting is completed, adjust the horizontal position of the lens when shooting, and automatically achieve horizontal balance, thus shooting a stable video picture.

Where is the horizontal line of Panasonic camera?

Panasonic's shooting interface, press the DISP key to switch the camera's shooting interface, so that you can use the electronic level function of the camera.

After the camera was mounted on a tripod, it was found that the horizontal and vertical lines were uneven before shooting. Which one can we use?

Within the range of adjusting the height of the horizontal support (leg), it can be basically solved by adjusting the height.

First of all, the landing position should be reliable, not in mud or gravel; Then the platform at the top of the tripod should be visually flat. The flatter it is, the easier it is to adjust the level of the instrument. Then put the instrument on the tripod and screw the nut at the bottom of the tripod platform into the level meter. At this time, you will find out whether the level bubble is not in the specified circle, as shown in the figure. Start leveling. During leveling, keep your eyes level and observe the movement of bubbles. The principle of leveling is that bubbles move upwards. The three adjusting nuts of the instrument can be rotated clockwise and counterclockwise, which means lowering the height and vice versa. According to the principle, we rotate the nut until it is leveled, then rotate the instrument120 to observe the leveling again, and then rotate120 to level again. Finally turned back to the original point. If all the bubbles can meet the requirements, the instrument should be adjusted. It can be observed and used, and always pay attention to bubbles during observation. So as to prevent the tripod from being manually collided and displaced to cause horizontal error.