Traditional Culture Encyclopedia - Travel guide - How does k2 router set up bridging?

How does k2 router set up bridging?

Bridging refers to the process of forwarding network packets according to the address of the link layer of the OSI network model, which works at the second layer of OSI. General switches, bridges have a bridging role. The following is how to set up a bridge in k2 router, which I collected for you. You are welcome to read and learn from it, and I hope it can help you.

How to set up a bridge for K2 router

The router is connected to a computer, and a desktop computer is used here. If it is a notebook phone, you can use wireless.

the lan port of the router is connected to the network card of the computer.

open the browser on your computer and enter the' login address of the router in the address bar. The login address of Fiji k2 is 192.168.2.1, or you can enter the p.to on the back of the router.

click quick configuration

to select the internet access mode, which is bridging, so this place is changed to automatic acquisition, and then the next step.

here is to modify the wireless name, and you can see two wireless options. You can set two different signal names, one is 2.4G and the other is 5G. Can be set to the same, can also be set to different names and passwords. There is an option "The administrator password is the same as the 2.4g wireless password" below. If the password is the same as the 2.4G wireless password, this setting is not recommended. Save to take effect.

after setting, you can see the words "setting has been completed". Here are the settings for bridging. Click, More Settings, and then click Advanced Settings. There is a wireless extension on the left

Click to open it, and there is a magnifying glass icon (behind the network name). After clicking, many signals appear

Select the wireless network name to be connected, click Connect, and if there is a password, you need to enter it, and then save it.

it's saved. check the system status. if there is an address in the wan port status, it generally means that the connection is good. You can surf the Internet. Try it.

Precautions

When the router is connected to the computer, it needs to be connected to the lan port.

When setting the wireless (if the wireless name or password is changed, it needs to be connected again)

How to restore the factory settings of the Fiji k2 router

Method 1: Reset button to restore the factory settings

Reset button means to restore the router to the factory settings with one button.

when Fiji K2 is powered on, press the WPS/RESET button for about 1 seconds by hand to restore this Fiji K2 router to its factory settings.

note: it is necessary to keep pressing the WPS/RESET button for about 1 seconds. some friends only press the WPS/RESET button once when operating, which leads to unsuccessful restoration of factory settings.

method 2. restore the factory settings in the setup interface

1. open the computer connected to the Fiji K2 router, open the browser on the computer, enter the login address p.to in the browser address bar, open the login page, and then enter the correct login password to log in to the router setup interface.

Tips: If you forget the login password, or if p.to can't be opened, we suggest that you use the method to restore the factory settings of Fiji K2.

2. Click the "Advanced Settings" option on the upper right to open it.

3. Click "System Settings"-> "Backup recovery"->; Click the "Restore Factory Settings" option in the right interface, as shown in the following figure;

4. click ok in the pop-up dialog box, as shown in the following figure.

5. Then Fiji K2 router will restore the factory settings, and you can see the progress of restoring the factory settings.

It is worth noting that once the factory settings of Fiji K2 router are restored, all the previously configured Internet access parameters will be cleared, just like when it was newly purchased, and it needs to be reconfigured to use the Internet again.