Pictures of 24 ways to tie shoelaces

Pictures of 24 kinds of shoelaces are introduced as follows:

First, the dual system method.

Second, the lattice system method.

Third, the upper and lower system method.

Fourth, the rope ladder method.

Five, single technique.

Sixth, the zipper method.

Seven, shoe store system.

Eight, sawtooth system method.

Eleven, riding boots method.

Twelve, after the double method.

Thirteen, hash system method.

Fourteen, chessboard system method.

Fifteen, double cross system method.

Sixteen, double helix method.

Seventeen, bow tie method.

Eighteen, knot segmentation method.

Nineteen, hidden knot method.

Twenty, the popular direct method.

Nineteen, hidden knot method.

Twenty, the popular direct method.

Twenty-one, cross method.

European direct law.

Twenty-three, lazy straight tie method.

Twenty-four, triathlon law.

Extended introduction:

First, Roman law:

This system, the pattern is a series of combinations of X and I, which is very similar to Roman numerals, so it is called Roman system. Simple, practical and beautiful, suitable for shoes with different shoelace holes.

1 is X-shaped, and the shoelace goes up through the left 1 and the left two shoelace holes. After straightening, the cross is X-shaped and penetrates from the right 2 and the right 1 respectively.

2, type I, right 1 shoelaces go out from the right 3, and go in to the left 3 to make a horizontal.

3. repeat it. Thread 3 shoelaces on the left from left 4 and 2 shoelaces on the right from right 4. The two shoelaces intersect to form an X, which passes through the left 5 and the right 5 respectively, and then passes through the sixth pair of holes.

Second, the pentagram system method:

Five-pointed star method, this method of tying shoelaces, is very cool and decorative.

1, one horizontal. Pass both ends of shoelaces through the fourth pair of holes and adjust them appropriately so that one side is longer than the other.

2. type X. The long end passes through the left side of 1 pair of holes, and the fourth pair of holes passes through the right side; Then it penetrates symmetrically from the right side of 1 pair of holes, and penetrates into the left side of the fourth pair of holes. Put an x on the five-pointed star.

3. Tie a horizontal line. Continue to put this toe cap out from the left side of the fifth hole and put it on the right side. This cross provides support for the vertex of the five-pointed star for the following steps.

4. It is V-shaped. Pass the shorter one in step 1 through the right side of the alignment hole of 1 and bypass the middle of the horizontal hole in step 3. Then penetrate from the left side of 1 hole.

5. Extend both ends of shoelaces, pull them out from the left and right top rows of holes, and adjust the tightness, so that the five-pointed star will appear.