Traditional Culture Encyclopedia - Weather forecast - How to disassemble the ignition knob of the eighth generation Accord?

How to disassemble the ignition knob of the eighth generation Accord?

The Accord igniter trim panel needs to pry open the key trim panel next to the central control, and then pry open the igniter trim panel. The igniter is on the right side of the steering wheel, near the central control. The cause of igniter damage is that the igniter fuse is blown, the ignition coil is damaged, the distributor is faulty or the battery is dead, which will lead to the ignition failure.

The causes of igniter failure are as follows:

1, the car stops suddenly when using the igniter, and there is no obvious law. After replacing platinum, the fault is eliminated or. Igniter circuit generally has false contact, grounding disconnection and other phenomena;

2. After a long period of exercise, the car was unstable and turned off, and returned to normal after cooling for a period of time. This phenomenon was not found when platinum was used. Generally, the igniter chip has the phenomenon of high-speed ignition failure, so the igniter needs to be replaced;

3. The car was normal before installing the igniter, but after installation and debugging, the engine started with serious jitter, sometimes accompanied by the phenomenon of exhaust pipe shooting. The ignition angle is still not improved after adjustment. Generally, the red and black wires of the sensor are connected backwards.

4. It is difficult to start a car with an igniter in cold weather, but it can be started normally when platinum is used, but it can be started by cart, traction and other methods. Generally, the sensor gap is too large. If the clearance is normal, observe whether the motor can rotate normally when starting. If the speed is too slow, it means that the motor sweeps the bore, the battery is dead, or the ground wire is poorly grounded.