How to connect the wireless shutter to the camera

Method/step of connecting the wireless shutter to the camera:

1. First, remove the hot boot cover on the top of the camera to expose the hot boots. You can see that the hot shoe lock nut at the bottom of the receiver matches it. If there are no hot boots, you may need to use other fixing methods.

2. Insert the receiver connector into the hot shoe and adjust the lock nut according to the indicated direction until it locks.

3. Connect both ends of the connecting cable to the receiver and the camera respectively, and pay attention to whether the position of the transmission hole is correct.

4. Turn on the switch of transmitter and receiver and tune to the same channel. You can see that the green light on the receiver flashes, indicating that the signal is received normally.

Turn on the power of the camera, and now you can control the camera with the transmitter. When the shooting button is half pressed, the green light of the transmitter lights up and the camera begins to focus. Press the shoot button completely, and the camera will take photos according to the settings. Next, set the camera and transmitter to the mode you need, and you can shoot.