Matters needing attention and retouching methods of manual operation

1. Don't throw away express boxes and packaging bags. Recycling is necessary.

2. Buy a double-sided tape and remove the glue from it. As long as the double-sided adhesive tape is white, it is attached to the edge of the painting (there is extra glue on the edge of the painting, which is easy to touch if you don't pay attention. Dirty is not qualified)

3. Check the canvas for quality problems, dirt, or take photos and report to me in time.

4. Check whether the color number of the drill is consistent with the color number card on the canvas, and report to me in time if there is any deficiency.

5. Don't use defective diamonds (notches, burrs, black spots and holes are all defective diamonds), only use complete and regular ones! When shaking the drill bit, put the defective drill bit aside and don't throw it away. Take a picture of me then, and fill the drill for free!

Below is a picture of a defective diamond for your reference.

6. Use of drill pen

Pay attention to the correct method of tearing ruler.

7. Newcomers are afraid that they can't stick it straight. You can use a ruler and follow the following method. When drilling, be sure to aim at the bottom ring on the canvas and make it straight! Every drill should cover the bottom ring.

8. Learn to stick a ruler and take a photo to see if it is straight!

9. 1. 1

It's crooked. How to adjust it?

Individual crooked, with drilling sound, press for a few seconds.

9. 1.2

There are many crooked rows, so adjust them with cards. Be careful not to insert the card directly. The thickness of the clamp will affect the displacement of the left and right rows of drill bits, and the clamp will bring up adhesive tape and dirty the drill bits.

9. 1.3

Or drill more styles.

10. When painting, don't tear the protective film on the painting too big, because there is glue on the painting. If you accidentally stain the canvas, tear it as big as you want.

1 1. When doing it, the first row of the canvas edge should not extend beyond the edge of the painting, but should be kept straight, or stuck in the second row or even inside, which will easily affect the straightness inside!

12. Unqualified pictures

13. Qualified samples

14. Packaging during recycling

Diamond painting requirements:

1, two directions are consistent, no drilling, less drilling and no outcrop,

2, the reverse side is clean and tidy without stains.

3, between the drill and drill clean without sundry, fiber, hair,

4. Blow the hair dryer with hot air after finishing. If you hold it, you won't fall off the drill.

This painting can't be folded in half. Can only be rolled up, rolled back, drilled outside, and rolled together with the original plastic film.

6. Drilling with holes, dyeing, bottom thickness, too big, too thin, not round, not smooth, together, can not be used.

7. Each painting has a chance to make up the drilling for free (it is recommended to make up the drilling together without any time limit).

8. After getting the painting, first glue the blank on the four sides of the canvas with plastic film to prevent it from getting dirty!

10, the glued positions are also covered with plastic film to prevent sticking (it is recommended to stick one piece at a time, because our paintings are relatively large, and the positions that do not stick to other colors are easy to get dirty).